Guitar and Mandolin Repairs : Kalamazoo Mandolin





This lovely old ‘30s Kalamazoo came into the workshop because it has a problem with its action.

Image

The action is very high and it’s not too long before the reason for this high action is spotted.

The neck is pulling up with the tension of the strings and a gap has appeared at the neck/body join.

Image  Image

According to its owner it had been attended to in the past but the repairer merely forced glue into the join, applied clamps and hoped for the best. Consequently over time the join has failed again.

The only means of dealing with this type of issue is to remove the neck and to make an assessment of the internal join.



The fingerboard extension is heated to release the glue. By teasing a little warm water into the join the hide glue is softened and the neck join becomes undone.

Image

The neck and body are held together with a simple French Dovetail. On close inspection of the dovetail it appears that it does not reach to its full height.

Image  Image

It is decided that a simple solution would be to extend the male half of the dovetail.

The end is trimmed down and a piece of Mahogany glued into place.

Image Image Image

As a safeguard an Ebony dowel is fashioned and inserted down through the body of the join.

Image Image

Veneer shims are added to the dovetail to ensure a snug fit.

Image

The join is assembled using hide glue and clamped.

Image

A few days later the mandolin is strung up, tuned and tested. The join is now gap free and the playing action is as it should be.

Click photo for Flickr pic set

Image

This lovely old mandolin has the beautiful tone of a mature instrument with the playability of a new mandolin, good for another 80 years!





Advertisements